How To Properly Use A Toilet Auger

Keep the auger’s screw taut before continuing. The spruce describes how to use a toilet auger using the following steps:

How To Use A Cobra Toilet Auger - Youtube

Insert the toilet auger cable.

How to properly use a toilet auger. Lay down a couple of towels or a sheet of plastic to protect the floor. Then get your auger ready and put on a pair of gloves. A toilet auger which is also known as a closet auger or a plumbing snake is a 3 to 6 feet long flexible cable with a coiled hooked head and a cranking handle that is used to unclog toilets.

Hold the toilet auger housing with one hand and use the other hand to crank the handle. While holding the toilet auger housing with one hand to keep it in place, hold the handle with your other hand and crank the auger to push the cable into the drain. Auger a toiletin this video, i show you how to snake a toilet using an auger.

Once you find that you can no longer turn the auger. Move the coiled extension deeper into the toilet by spinning the handle. Place the auger into toilet bowl with the curved portion of the crank facing into the drainpipe.

Keep doing this until you reach the clog. If it drains to the back, curve the auger to the back. Pull up the handle so that the cable end is close to the bottom of the auger tube’s curved end to make feeding the tube in easier and to stop the toilet bowl from getting scratched.

If playback doesn't begin shortly, try restarting your device. It works by pulling out the clog or breaking it into smaller pieces which can easily flow down the drain. How to unclog a toilet:

Turn the handle for the drain auger clockwise to start the cable through the drain. I watched other people's videos but the men assumed the. Once you finish using the toilet auger, chances are that it might have some debris on it.

Once you are sure that the auger is positioned in alignment with the drain, you need to push the cable through the toilet while turning it clockwise. Is a toilet auger the same as a snake? Watch as ace's home expert, lou manfredini, shows you how to use a toilet auger to unclog a toilet.always follow manufacturer's instructions before using any.

One of the most common tools for unclogging a toilet is the toilet auger. Apart from this, depending on the design of the toilet auger, it can recoil back and injure you. Clean and dry your auger.

So if your john drains to the front, curve the auger to the front. Insert its guide tip, while making sure the curve is facing the direction of the drain. How to use a toilet auger.

The actual handle should not go inside the drain only the cabling. Turn the handle for the drain auger clockwise to start the cable through the drain. Curve the end of your toilet auger in the direction that your toilet drains.

Read on and learn how to use it! Insert the spring end of the auger into the toilet and down the pipe. How to use a toilet auger.

Pull the cable back a little when you reach a corner by turning the handle counterclockwise. Pull the cable back a little when you reach a corner by turning the handle counterclockwise. Turn off the water supply valve behind your toilet so you don't have a messy overflow on your hands.

Using a toilet auger is quite simple, and the tool itself is rudimentary but effective. Strategy for using a toilet auger. Cover the floor around the toilet.

Subsequently, question is, is a toilet auger the same as a snake? This curved elbow portion will make feeding the cable into the toilet easier, and the rubber or plastic sleeve will protect the toilet from scratches. Using extra muscle to crank the handle will bind the flexible snake and make the rod to break or even get bound up in the waste line.

How to use a toilet auger. One of the most common tools for unclogging a toilet is the toilet auger. It’s possible that water may splash out of the toilet bowl as the snake works on the.

The turning will allow it to bend more easily as it curves through the drain. Pull the auger handle up all the way so that the end of the cable is close to the bottom curved end of the auger tube. Set a distance allowance of 4 to 6 inches between the toilet’s hole and the end of your curved pipe handle.

You must start by pushing the cable through the toilet drain while turning it in a clockwise motion.

How To Use A Toilet Auger Everything Youll Need To Know